Standing seam and metal panel roofing, roof repair and full replacement in Bellevue. We show up when we say we will, and we clean up before we go.
Everything we do on a roof, done by crews who have been doing it the same careful way since 2002.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
Low slope roofs fail at the joints and around anything that sticks through them. That is where we start, not out in the middle of the field.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
An older roof deserves to keep its character. We repair rather than replace wherever the material still allows it.
One leak usually has company. We fix the one you called about and check over the rest of the roof while we are already up there.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
A shingle repair should not be visible from the street. We match as close as the weathering allows and blend the new work into the old.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
We work around your hours, weekends included when that is what it takes to keep your doors open while the roof goes on.
Removing the ice is the easy half. We also look at ventilation and insulation so it stops happening every January.
We match the guard to your trees and your gutter profile, and make sure water can still get in where it is supposed to.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
Small repairs get the same crew and the same care as a full roof. Free estimate, a price in writing, and the work done before the next rain moves in.
Storm damage does not wait for business hours. We get the opening closed, photograph it for your insurance, and put the real fix on the schedule.
Standing seam and metal panels have been our specialty since 2002. Around Bellevue that means everything from a small porch roof to a full house in dark green, burgundy or bronze, cut and fit on site by crews who have done hundreds of them.
A metal roof done right in Bellevue should be quiet inside, straight from the street, and still there long after you have stopped thinking about it. That takes sound decking, real underlayment, and panels that are actually square. We do not skip those parts to save a day.
Why people around Bellevue call us back and send their neighbors our way.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Straight answers to what Bellevue homeowners ask us most often.
We do. After a storm we photograph the damage on your Bellevue roof and write an itemized estimate you can hand to your adjuster. We do not file the claim for you and we will not promise you what an adjuster is going to approve — that is their call, not ours.
Any dry stretch works. We roof in Bellevue year round, though we schedule shingle work for when it is warm enough for the strips to seal properly, and we watch the forecast so your house is never left open overnight.
Often, yes. Plenty of the Bellevue roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
For most Bellevue homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
A metal roof installed properly on a Bellevue home should give you 40 to 60 years, and standing seam often goes longer because there are no exposed fasteners. Screws and sealants on a panel roof want attention around year 20, which is a small job next to a re-roof.
Most Bellevue metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Real feedback from homeowners whose roofs we have worked on.
"Ice was backing up at our eaves every winter. They cleared it, then went back and fixed the ventilation, and we have not had the problem since."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Our church needed a new roof and the budget was tight. They worked with us on it, did beautiful work, and finished before the fall revival."
Our crews cover the surrounding area, not only the city limits.